References
[1]. Neufeld, N. (2013). “Introduction to Detector Readout
and Front End Electronics”. ISOTDQ 2013.
[2]. Geronimo, G. D., and Li, S. (2011). “Shaper Design in
CMOS for High Dynamic Range”. IEEE Trans. Nucl. Sci. IEEE
Transactions on Nuclear Science, Vol. 58, No. 5, pp. 2382-
2390.
[3]. Knoll, G.F. (1979). Radiation Detection and
Measurement. New York: Wiley
[4]. Konrad, M. (1968). “Detector Pulse Shaping for High
Resolution Spectroscopy”. IEEE Trans. Nucl. Sci. IEEE Transactions
on Nuclear Science, Vol. 15, No. 1, pp. 268-282.
[5]. Salama, K.N., and Soliman, A.M. (1999). “CMOS
Operational Transresistance Amplifier for Analog Signal
Processing”. Microelectronics Journal, Vol. 30, No. 3, pp.
235-245.
[6]. Pandey, R., Pandey, N., and Paul, S.K. (2012). “MOS-C
Third Order Quadrature Oscillator Using OTRA”. 2012 Third
I n t e r n a t i o n a l C o n f e re n c e o n C omp u t e r a n d
Communication Technology
[7]. Pandey, R., (2014). “Signal processing and generating
circuits using OTRA as a building block”. Retrieved from
Shodhganga (http://hdl.handle.net/10603/31644),
University of Delhi.
[8]. Noulis, T., Deradonis, C., and Siskos, S. (2006). “Design
and Comparison of CMOS CCII Based Shapers for Detector
nd Readout Front Ends”. IEEE 2 Conf. on Ph.D. Research in
Microelectronics and Electronics, pp. 149-152.
[9]. Noulis, T., Deradonis, C., and Siskos, S. (2007a). “Advanced Readout System IC Current Mode Semi-
Gaussian Shapers Using CCIIs and OTAs”. VLSI Design, 2007,
pp. 1-12.
[10]. Noulis, T., Deradonis, C., and Siskos, S. (2007b).
“Design guidelines and comparison of detector readout
front end integrated S-G shapers using transconductance
circuits”. International Journal of Electronics, Vol. 94, No.
10, pp. 943-959.
[11]. Noulis, T., Deradonis, C., Siskos, S., and Sarrabayrouse,
G. (2008). “Particle detector tunable monolithic Semi-
Gaussian shaping filter based on transconductance
amplifiers”. Nuclear Instruments and Methods in Physics
Research Section A: Accelerators, Spectrometers,
Detectors and Associated Equipment, Vol. 589, No. 2, pp.
330-337.
[12]. Noulis, T., Voulkidou, A., Siskos, S., and Sarrabayrouse,
G. (2010). “Current mode low BW-large peaking time
CMOS S-G shaper using CA building cells”. Melecon 2010-
th 2010 15 IEEE Mediterranean Electrotechnical Conference,
pp. 290-295.
[13]. Pandey, N., Pandey, R., and Sayal, A. (2013a). “CDTA
based semi Gaussian shapers for detector readout front
ends”. 2013 International Conference on Circuits, Power
and Computing Technologies (ICCPCT), pp. 703-708.
[14]. Pandey, N., Sayal, A., and Pandey, R. (2013b).
“DDCCTA based semi Gaussian shapers for detector
readout front ends”. 2013 International Conference on
Circuits, Power and Computing Technologies (ICCPCT).
[15]. Mostafa, H., and Soliman, A. M. (2006). “A Modified
CMOS Realization of the Operational Transresistance
Amplifier (OTRA)”. Frequenz, Vol. 60, No. 3-4.
