i-manager Publications

Characterization of Cold-Sprayed NiCoCrAlY Coatings on Fe-Based Superalloy and Hot Corrosion Behavior in Na2SO4-NaCl Environment

Sukhminderbir Singh Kalsi*, T.S. Sidhu**, Harminder Singh***

* Research Scholar, Punjab Technical University, Kapurthala, Punjab, India.

** Shaheed Bhagat Singh College of Engineering & Technology, Ferozpur, (Punjab), India.

*** Guru Nanak Dev University, Regional Campus, Jalandhar, Punjab, India.

Periodicity:August - October'2013
DOI : https://doi.org/10.26634/jfet.9.1.2479

Abstract

In the present study cold spraying was used to deposit and NiCoCrAlY coating on Fe-based Superfer 800H superalloy and coating was successfully deposited with cold spray process. As sprayed coating was tested for microhardness, thickness and microstructure. The hot corrosion behavior of the bare and coated superalloy is evaluated in Na2SO4-10% NaCl environment at 900°C under cyclic conditions. The microstructural characteristics of the corrosion products were investigated with XRD, SEM, EDAX and Elemental X-Ray Mapping. The cold sprayed NiCoCrAlY coating perform better as compare to bare superalloy against hot corrosion degradation. Dense coating structure obtained by the cold spray technique and protective oxide layer on the top are responsible for better performance of the coating.

Keywords

Cold Spray, Coating, Hot Corrosion

How to Cite this Article?

Kalsi, S. S., Sidhu , T.S., and Singh, H. (2013). Characterization of Cold-Sprayed NiCoCrAlY Coatings on Fe-Based Superalloy and Hot Corrosion Behavior in Na2SO4-NaCl Environment. i-manager’s Journal on Future Engineering and Technology, 9(1), 15-26. https://doi.org/10.26634/jfet.9.1.2479

References

[1]. Bala, N., Singh, H., & Prakash, S. (2010). Accelerated hot corrosion studies of cold spray Ni–50Cr coating on boiler steels, Materials and Design 2010, 31, 244–253.

[2]. Bala, N., Singh, H., & Prakash, S. (2010). High Temperature Corrosion Behavior of Cold Spray Ni-20Cr Coating on Boiler Steel in Molten Salt Environment at 900oC, Journal of Thermal Spray Technology, 19(1-2), 110-118.

[3]. Bala, N., Singh, H., & Prakash, S. (2011). Characterization and High-Temperature Oxidation Behavior of Cold-Sprayed Ni-20Cr and Ni-50Cr Coatings on Boiler Steels, Metallurgical and Materials Transactions A, 42(a), 3399-3416.

[4]. Edris, H., McCartney, D.G., & Sturgeon, A. J. (1997). Microstructural characterization of high velocity oxy-fuel sprayed coatings of Inconel 625 Material Science, 32, 863–868.

[5]. Gao, Y., Chen, M. C., & Shi, C. X. (1999). Study on EB-PVD Zirconia thermal barrier coatings for gas turbine blade protection. Materials and Manufacturing Processes, 14(5), 691-696.

[6]. Goyal, T., Walia, R. S., & Sidhu, T. S. (2012). Effect of Parameters on Coating Density for Cold Spray Process, Materials and Manufacturing Processes, 27(2), 193-200.

[7]. Goyal, T., Walia, R. S., & Sidhu, T. S. (2012). Study of Coating Thickness of Cold Spray Process Using Taguchi Method. Materials and Manufacturing Processes, 27(2), 185-192.

[8]. Gurrappa, I. (2000). Hot corrosion of protective coatings. Materials and Manufacturing Processes 2000, 15(5), 761-773.

[9]. Hanyi, L., Fuhui W. & Linxiang B. (1990). Effect of Yttrium on the Hot-corrosion Resistance of Sputtered Co-Cr-Al Coatings”, Material Science and Engineering A, 123, 123-128.

[10]. Jodoin, B., Ajdelsztajn, L., Sansoucy, E., Zuniga, A., Richer, P., & Lavernia, E.J. (2006). Effect of particle size, morphology, and hardness on cold gas dynamic sprayed aluminum alloy coatings. Surface and Coatings Technology, 201(6), 3422–3429.

[11]. Kamala, S., Jayaganthan, R., Prakash, S., & Kumar, S. (2008). Hot corrosion behavior of detonation gun sprayed Cr3C2–NiCr coatings on Ni and Fe-based superalloys in Na2SO4–60% V2O5 environment at 900 ?C. Journal of Alloys and Compounds, 463(1-2), 358-372.

[12]. Luthra, K. L., (1985). Kinetics of the Low Temperature Hot Corrosion of Co-Cr-Al Alloys, J. Electrochem. Soc.,132(6), 1293-1298.

[13]. Matsubara, Y., Sochi, Y., Tanabe, M., & Takeya, A. (2007). Advanced Coatings on Furnace Wall Tubes. Journal of Thermal Spray Technology, 16(2), 195-201.

[14]. Patnalk, P. C., & Immarigeon, J. P. (1989). Protective coatings for aero engine hot section components, Materials and Manufacturing Processes. 4(3), 347-384.

[15]. Rapp R. A. (1986). Chemistry and electrochemistry of the hot corrosion of metals. Corrosion, 42, 568–577.

[16]. Rapp, R.A., & Zhang Y.S., (1994). Hot corrosion of materials : Fundamental studies, JOM, 46(12), 47-55.

[17]. Richer, P., Yandouzi, M., Beauvais, L., & Jodoin, B. (2010). Oxidation behaviour of CoNiCrAlY bond coats produced by plasma, HVOF and cold gas dynamic spraying. Surface and Coatings Technology, 204, 3962–3974.

[18]. Sidhu, B. S., & Prakash, S., (2006). Erosion-corrosion of plasma as sprayed and laser remelted Stellite-6 coatings in a coal fired boiler, Wear, 260, 1035–1044.

[19]. Sidhu, T. S., Agrawal, R. D., & Prakash, S. (2005). Hot corrosion of some superalloys and role of high-velocity oxy-fuel spray coatings—a review. Surface & Coatings Technology, 198, 441– 446.

[20]. Sidhu, T. S., Prakash, S., & Agrawal, R. D. (2006). Performance of a High Velocity Oxy-fuel Sprayed coating on a Fe-Based Superalloy in Na2SO4-60%V2O5 Environment at 900oC, Part II: Hot Corrosion Behaviour of the Coatings, Mater. Engg. Perform., 15(1), 130-138.

[21]. Singh, H., Puri, D., & Prakash, S. (2005). Some Studies on Hot Corrosion Performance of Plasma Sprayed Coatings on Fe-based Superalloy. Surface and Coatings Technology, 192(1), 27-38.

[22]. Singh, H., Sidhu, T. S., & Kalsi, S. B. S. (2012). Cold spray Technology future of coating deposition process. Frattura ed Integrità Strutturale, 22, 69-84.

[23]. Singh, H., Sidhu, T. S., Kalsi, S. B. S., & Karthikeyan, J. (2013). Development of cold spray from innovation to emerging future coating technology, J Braz. Soc. Mech. Sci. Eng. 2013.

[24]. Tiwari, S. N., & Prakash, S. (1997). Studies on the Hot Corrosion Behaviour of Some Superalloys in Na2SO4-V2O5, Proc. of SOLCEC, Kalpakkam, India, 22-24th Jan., Paper C33.

[25]. Wang, Q. M., Wu, Y. N., Ke, P. L., Cao, H. T., Gong, J.,Sun, C. & Wen, L. S. (2004). Hot Corrosion Behavior of AIP NiCoCrAlY(SiB) Coatings on Nickel Base Superalloys, Surface and Coatings Technology, 186, 389-397.

Characterization of Cold-Sprayed NiCoCrAlY Coatings on Fe-Based Superalloy and Hot Corrosion Behavior in Na2SO4-NaCl Environment

Abstract

Keywords

How to Cite this Article?

References

If you have access to this article please login to view the article or kindly login to purchase the article

Purchase Instant Access

Options for accessing this content:

	North Americas,UK, Middle East,Europe		India	Rest of world
	USD	EUR	INR	USD-ROW
Pdf	35	35	200	20
Online	35	35	200	15
Pdf & Online	35	35	400	25