i-manager Publications

Distribution System Reliability Assessment with Distributed Generation

K. Amaresh*, V.Sankar**

* Associate Professor, Department of EEE, KSRM College of Engineering, Kadapa, India.

** Professor in Electrical Engineering, Director of Academic Planning, JNTUA, Anantapur, India.

Periodicity:August - October'2013
DOI : https://doi.org/10.26634/jps.1.3.2461

Abstract

Reliability assessment of a radial distribution system with a distributed generation is presented in this paper. Assessment of customer power supply reliability is an important part of distribution system operation and planning. DG distribution is likely to improve the reliability of a power distribution system by at least partially minimizing the chance of power interruptions to customers due to loss of utility generators or due to faults in transmission and distribution lines or equipment. DG is expected to improve the system reliability as its back up generation. Since, DG units are subject to failures like all other generation units, the random behavior of these units must be taken into account in the analysis. Existence of DG units in a distribution system will affect restoration time of load points. In this paper, an algorithm for assessing restoration time of load points for a radial distribution system with back up DG units is presented. A simple distributed load flow technique has been used for solving radial distribution network by placing DG and compared with base case. The location of DGs is attained based on the corresponding lowest voltage values at the particular load point. A sensitivity analysis is performed on a test system to examine the impact of DG units, their location and their number on reliability indices. The proposed approach is tested on an IEEE – 15 bus radial distribution system, the results are presented and analyzed.

Keywords

Reliability Assessment, Distribution System, Distributed Generation, Restoration Time, Distributed Load Flow, Sensitivity Analysis

How to Cite this Article?

Amaresh, K., and Sankar, V. (2013). Distribution System Reliability Assessment With Distributed Generation. i-manager’s Journal on Power Systems Engineering, 1(3), 1-7. https://doi.org/10.26634/jps.1.3.2461

References

[1]. L.H. Deng, X.Y. Chen (2004). “Review of Distribution System Reliability Evaluation”, Electric Power Automation Equipment, 24.4, pp. 74-77.

[2]. Kersting. W.K., Philips. W.H., Doyle. R. Clay (1999), “Distribution Feeder Reliability Studies”, IEEE Transaction on Industry Application, 35.2., pp. 319-323.

[3]. A.F. Khoshbakht, M. Raoofat (2008), “Optimal Allocation of DG and RCS to improve distribution network Reliability and Network Energy Losses”, 2nd IEEE Imtenational Conference on Power and Energy (PECON 08), Johar Baharu, Malaysia, December 1-3.

[4]. I. Waseem, M. Pipattanasomporn, S. Dahman (2009), “Reliability Benefits of DG as a Backup Source”, Power and Energy Society General Meeting.

[5]. I. Ziari, G. Ledwich, A. Ghosh, D. Cornforth, M. Wishart (2010), “Optimal Allocation and Sizing of DGs in Distribution Networks”, PES General Meeting,USA.

[6]. Sandeep Kaur and Vivek Goyal (2011), “Classical Approach for Optimal Allocation of DG in a Distribution System”, International Conference on Deregulated Energy and Environment Management at Chitkara University, July.

[7]. R.K.Singh and S. Goswami (2010), “Optimal Allocation of DG based on Nodal Pricing for Profit, Loss Reduction and Voltage Improvement including Voltage Rise Issue”, Electric Power System Research, Vol. 36, No.6, July, pp.637-644.

[8]. Seyed Ali Mohammad Javadian and Maryam Massaeli (2011), “Impact of DG on Distribution System Reliability Considering Recloser-Fuse Mis-coordination – A Practical Case Study”, Indian Journal of Science and Technology, Vol.4, No.10, pp.1279-1284, Oct.

[9]. Y.M. Afwa and E.F. El-Saadany (2009), “Reliability Evaluation for Distribution System with Renewable Distributed Generation during Islanded Mode of Operation”, IEEE Trans. Power Systems, Vol.24, No.2, pp. 572-581, May.

[10]. S. Dimitrijevic and N. Rajakovic (2011), “An Innovative Approach for Solving Restoration Problem in Distribution Networks”, Electric Power System Research, Vol. 81, No.10, pp. 1961-1972.

[11]. M. Fotuhi – firuzabad, Abbas Rajabi-Ghahnavie (2005), “An Analytical Method to Consider DG Impacts on distribution System Reliability”, IEEE/PES Displacement and Distribution Conference and Exhibition, Asia and Pacific.

[12]. P. Jahangiri and M. Fotuhi-Firuzabad (2008), “Reliability Assessment of Distribution System with Distributed Generation”, 2nd IEEE International Conference on Power and Energy, Dec, Malaysia, pp. 1551-1556.

[13]. H. Falaghi, M.R. Haghifam (2005), “Distributed Generation Impacts on Electric Distribution System Reliability: Sensitivity Analysis”, Computer as a Tool, 2005, EUROCON 2005, The International Conference on Vol.2, No.10, pp. 1465-1468.

[14]. M. Srinivas (2000), “Distribution Load Flows – A brief Review”, in proceedings IEEE PES Winter Meeting, Vol.2, Jan, pp. 942-945.

[15]. Satyanarayana. S, Ramana.T, Sivanagaraju.S, Rao.G.K (2007), “An Efficient Load Flow Solution for Radial Distribution Network Including Voltage Dependent Load Models”, Electric Power Components and Systems, 35(5), pp.539-551.

[16]. K. Amaresh, S. Sivanagaraju and V. Sankar (2006), “Minimization of Losses in Radial Distribution System by using HVDS”, IEEE Power Electronics, Drives and Energy Systems, 2006. PEDES 2006, International Conference on 12-15 Dec, pp.1-5.

Distribution System Reliability Assessment with Distributed Generation

Abstract

Keywords

How to Cite this Article?

References

If you have access to this article please login to view the article or kindly login to purchase the article

Purchase Instant Access

Options for accessing this content:

	North Americas,UK, Middle East,Europe		India	Rest of world
	USD	EUR	INR	USD-ROW
Pdf	35	35	200	20
Online	35	35	200	15
Pdf & Online	35	35	400	25