i-manager Publications

Pendulam Impact Test on RCC and SFRC Plates

S. Elavenil*

*Professor in Civil Engineering, School of Mechanical and Building Sciences, V.I.T.University (Chennai Campus),Vandalur, Chennai.

Periodicity:June - August'2013
DOI : https://doi.org/10.26634/jste.2.2.2381

Abstract

Concrete structures are often subjected to various types of dynamic forces. Fibre reinforcement improves the dynamic behavior of reinforced concrete plates under impact loading. The paper reports an experimental investigation on the dynamic behavior of Steel Fibre Reinforced Cement Concrete (SFRC) plates under pendulum impact test. The variables considered were percentage volume fraction of steel fibres, aspect ratio, the angle of impact and the thickness of the plate. The peak amplitude versus frequency behavior of Steel Fibre Reinforced Concrete plates was studied. The magnitude of amplitude increases in the order of 30% for Steel Fibre Reinforced Concrete plates fixed on two sides as compared to plates fixed on all four sides. The increase in aspect ratio of steel fibres shows a 30% higher frequency. It is observed that the drop in the peak amplitude is gradual for steel fibre reinforced plates fixed on four sides. Based on the peak amplitude versus frequency behaviour, the numerical expression for amplitude in terms of frequency is suggested.

Keywords

Dynamic Response, Frequency Of The Plate, Steel Fibres And Amplitude

How to Cite this Article?

Elavenil, S. (2013). Pendulam Impact Test on RCC and SFRC Plates. i-manager’s Journal on Structural Engineering, 2(2), 1-8. https://doi.org/10.26634/jste.2.2.2381

References

[1]. Ayaho Miyamoto., Michael W. King, & Manabu Fujii. (1991). “Non Linear Dynamic Analysis of Reinforced Concrete Slabs Under Impulsive Loads”, ACI Structural Journal, Vol.88, No.4, pp. 411 - 419.

[2]. Bhat, R.B., Laura, P.A.A., Gutierrez, R.G., & Cortinez V.H. (1990). “Numerical Experiments on the Determination of Natural Frequencies of Transverse Vibrations of Rectangular Plates of Non - Uniform Thickness”, Journal of Sound and Vibration, Vol.138, No.2, pp. 205 - 219.

[3]. Craig, M., Newtson, & Marc O. Eberhard. (2000). “Nondestructive Evaluation Using Numerical Simulation of Impact Response”, ACI Material Journal, Vol.97, No.3, pp. 343 - 350.

[4]. Dawe, D.J & Wang S. (1994). “Buckling of Composite Plates and Plate Structures Using the Spline Finite Strip Method”, Composite Engineering, Vol.4, No.11, pp. 1099 - 1117.

[5]. Deolasi P.J., Datta., P.K & Prabhakara, D.L. (1995). “Buckling and Vibration of Rectangular Plates Subjected to Partial Edge Loading”, Journal of Structural Engineering, Vol.22, No.3, pp.135 - 144.

[6]. Elavenil.S., Radhakrishnan.,Elangovan.a.,. R.,Arumugam. (2005). “ Dynamic behaviour of steel fibre reinforced concrete plates”, Journal of Structural Engineering, Vol.18(3) July, pp:89-98.

[7]. Elavenil.S, Samuel Knight .G.M. (2006) “ Study on the Dynamic Behaviour of SFRC and RCC plates using Finite Element Method” Journal of American Science, Vol.2, No.4 pp 1 –8.

[8]. Ercoli, L., Laura, P.A.A., & Gil, R. (1990). “Fundamental Frequency of Vibration of Rectangular Plates of Discontinuously Varying Thickness with a Free Edge: Analytical and Experimental Results”, Journal of Sound and Vibration, Vol.141, No.2, pp. 221 -229.

[9]. Glovanni Belingardi., & Roberto Vadori. (2003), “Influence of the Laminate Thickness in Low Velocity Impact Behaviour of Composite Plate”, Composite Structures, Vol.61 pp. 27 -38.

[10]. Gajbir Singh., Kanaka Raju, K., Venkateswara Rao G. (1990). “Non Linear Vibrations of Simply Supported Rectangular Cross - Ply Plates”, Journal of Sound and Vibration, Vol.142, No.2, pp. 213 - 226.

[11]. Gorman, D.J & Wei Ding. (2003). “Accurate Free Vibration Analysis of Completely Free Symmetric Cross - Ply Rectangular Laminated Plates”, Composite Structures, Vol.60, pp. 359 - 365.

[12]. Humayun, R. H., Kabir. (2004). “Free Vibration Response and Mode Shapes of Arbitrarily Laminated Rectangular Plates”, Composite Structures, Vol.65 pp. 13 - 27.

[13]. Kobayashi, H. & Sonoda, K. (1991). “Vibration and Buckling of Tapered Rectangular Plates with Two Opposite Edges Simply Supported and the other Two Edges Elastically Restrained Against Rotation”, Journal of Sound and Vibration, Vol.146, No.2, pp. 323 -337.

[14]. Li., Jian Bao Li., & Rou Qi Zhang. (2004). “Energy - Absorption Performance of Porous Materials in Sandwitch Composites Under Hypervelocity Impact ling”, Composite Structures, Vol .64, pp. 71 -78.

[15]. Mili F., &d Necib B. (2001). “Impact Behaviour of Cross Ply Laminated Composite Plates Under Low Velocities”, Composite Structures, Vol.51, pp. 237 - 244.

[16]. Ong, K.C.G., Basheerkhan, M., & Paramasivam P. (1999),.“Resistance of Fibre Concrete Slabs to Low Velocity Projectile Impact”, Cement and Concrete Composites, Vol.21, pp. 391 – 401.

[17]. Schrader., Ernest., K. (1981). 'Impact resistance and test procedure for concrete', ACI Journal Proceedings, Vol.78,No.2,Mar – apr. pp.141 – 146.

[18]. Serge Abrate. (2001). “Modeling of impacts on composite structures”,Composite Structures, Vol. 51,pp.129-138.

	North Americas,UK, Middle East,Europe		India	Rest of world
	USD	EUR	INR	USD-ROW
Pdf	35	35	200	20
Online	35	35	200	15
Pdf & Online	35	35	400	25

Pendulam Impact Test on RCC and SFRC Plates

Abstract

Keywords

How to Cite this Article?

References

If you have access to this article please login to view the article or kindly login to purchase the article

Purchase Instant Access

Options for accessing this content: