i-manager Publications

Exergy Efficiency and Exergy Destruction Assessment of Heat Transfer and Fluid Flow through Spiral Passages using Source-Sink Model

Faraj El-Sagier*

Department of Mechanical and Industrial Engineering, University of Tripoli, Tripoli, Libya.

Periodicity:October - December'2023
DOI : https://doi.org/10.26634/jfet.19.1.20233

Abstract

Exergy efficiency and exergy destruction of forced turbulent convective fluid flow through spiral passages using sourcesink model are assessed. Constant and temperature dependent thermophysical properties of process fluid in sink regions have been considered, while in the source regions phase change material is kept at constant temperature. Moreover, the effect of a secondary flow phenomenon due to spiral motion of the fluid flow through narrowing spiral passages has been evaluated in the sink passage domain. It was found that this phenomenon plays an important role in decreasing the exergy destruction as a result of energy exchange between source and sink in this compact type of energy carrier or storage equipment. It was found that the De (Dean Number) whose magnitude is a measure of the secondary flow, has positive impact on exergy efficiency while decreasing along the spiral passage. The fluid properties that are temperature dependent have a significant influence on the enhancement of heat transfer process, exergy efficiency and exergy destruction. It is concluded that the source-sink model could be considered from engineering point of view as a good simple model for evaluating the thermodynamic performance of this type of thermal energy process device.

Keywords

Exergy Destruction, Exergy Efficiency, Turbulent Convective, Spiral Passage, Secondary Flow, Dependent Thermophysical Properties, Source-Sink Model.

How to Cite this Article?

El-Sagier, F. (2023). Exergy Efficiency and Exergy Destruction Assessment of Heat Transfer and Fluid Flow through Spiral Passages using Source-Sink Model. i-manager’s Journal on Future Engineering & Technology, 19(1), 9-18. https://doi.org/10.26634/jfet.19.1.20233

References

[1]. Ashrafizadeh, S. A. (2019). Application of Second Law Analysis in Heat Exchanger Systems. Entropy, 21(6), 606.

[2]. Bejan, A. (1979). A study of entropy generation in fundamental convective heat transfer. ASME Journal of Heat and Mass Transfer, 101(4), 718-725.

[3]. Bejan, A. (1980). Second law analysis in heat transfer. Energy, 5(8-9), 720-732.

[4]. Bejan, A. (1982). Entropy Generation through Heat and Fluid Flow. Wiley, New York.

[5]. Bejan, A. (1988). Advanced Engineering Thermodynamics. Wiley & Sons. New York.

[6]. Bejan, A. (1995). Entropy Generation Minimization: The Method of Thermodynamic Optimization of Finite-Size Systems and Finite-Time Processes. CRC press.

[7]. Bhatti, M. S. (1987). Turbulent and Transition Flow Convective Heat Transfer in Ducts. Handbook of Single-Phase Convective Heat Transfer.

[8]. Bucsa, S., Dima, D., Serban, A., Stefanescu, M. F., Popa, V., & Dobrovicescu, A. (2019, September). Heat exchanger design based on minimum entropy generation. In IOP Conference Series: Materials Science and Engineering, 595(1), 012020. IOP Publishing.

[9]. El-Sagier, F. (2022a). Convential exergy aspect of heat transfer and fluid flow through spiral passage subjected to consant wall temperature. i-manager's Journal on Future Engineering & Technology, 17(3), 1.

[10]. El-Sagier, F. (2022b). Parametric Analysis of entropy generation in turbulent convective forced flow in spiral channels at constant wall temperature. i-manager's Journal on Mechanical Engineering, 12(2), 22.

[11]. Mahmud, S., & Fraser, R. A. (2002). Second law analysis of heat transfer and fluid flow inside a cylindrical annular space. Exergy, an International Journal, 2(4), 322-329.

[12]. Maxwell, M. J., & Ghajar, A. J. (1985). Laminar forced-convective heat transfer with varying properties in the entrance region of flat rectangular ducts. Heat Transfer Engineering, 6(4), 31-38.

[13]. Milovančević, U. M., Jaćimović, B. M., Genić, S. B., El-Sagier, F., Otović, M. M., & Stevanović, S. M. (2019). Thermoeconomic analysis of spiral heat exchanger with constant wall temperature. Thermal Science, 23(1), 401-410.

[14]. Mondal, R. N., Huda, M. A., Ahmmed, S. F., & Tarafder, D. (2007). Effects of secondary flow on convective heat transfer through a curved rectangular duct. Journal of Applied Sciences Research, 3(12), 1842-1850.

[15]. Öztop, H. F., Şahin, A. Z., & Dağtekin, İ. (2004). Entropy generation through hexagonal cross sectional duct for constant wall temperature in laminar flow. International Journal of Energy Research, 28(8), 725-737.

[16]. Rohsenow, W. M., Hartnett, J. P., & Cho, Y. I. (1998). Handbook of Heat Transfer. Mcgraw-hill, New York.

[17]. Sabouri Shirazi, A. H., Jafari Nasr, M. R., & Ghodrat, M. (2020). Effects of temperature differences in optimization of spiral plate heat exchangers. Process Integration and Optimization for Sustainability, 4(4), 391-408.

[18]. Şahin, A. Z. (1998a). A second law comparison for optimum shape of duct subjected to constant wall temperature and laminar flow. Heat and Mass Transfer, 33(5-6), 425-430.

[19]. Şahin, A. Z. (1998b). Irreversibilities in various duct geometries with constant wall heat flux and laminar flow. Energy, 23(6), 465-473.

[20]. Şahin, A. Z. (2000). Entropy generation in turbulent liquid flow through a smooth duct subjected to constant wall temperature. International Journal of Heat and Mass Transfer, 43(8), 1469-1478.

[21]. Sahin, A. Z. (2002). Entropy generation and pumping power in a turbulent fluid flow through a smooth pipe subjected to constant heat flux. Exergy, an International Journal, 2(4), 314-321.

[22]. Sayyaadi, H. (2020). Modeling, Assessment, and Optimization of Energy Systems. Academic Press.

[23]. Sekulic, D. P., Campo, A., & Morales, J. C. (1997). Irreversibility phenomena associated with heat transfer and fluid friction in laminar flows through singly connected ducts. International Journal of Heat and Mass Transfer, 40(4), 905-914.

[24]. Talebi, M. (2010). Entropy generation analysis of a variable property fluid convection in a helical tube. World Applied Science Journal, 10(4), 406-415.

[25]. Yee, G., Chilukuri, R., & Humphrey, J. A. C. (1980). Developing flow and heat transfer in strongly curved ducts of rectangular cross section. ASME Journal of Heat and Mass Transfer, 102(2), 285-291.

	North Americas,UK, Middle East,Europe		India	Rest of world
	USD	EUR	INR	USD-ROW
Pdf	35	35	200	20
Online	35	35	200	15
Pdf & Online	35	35	400	25

Exergy Efficiency and Exergy Destruction Assessment of Heat Transfer and Fluid Flow through Spiral Passages using Source-Sink Model

Abstract

Keywords

How to Cite this Article?

References

If you have access to this article please login to view the article or kindly login to purchase the article

Purchase Instant Access

Options for accessing this content: