References
[1]. Jain, S., & Agarwal, V. (2007). A single-stage grid
connected inverter topology for solar PV systems with
maximum power point tracking. IEEE Transactions on
Power Electronics, 22(5), 1928-1940. https://doi.org/10.1109/TPEL.2007. 904202
[2]. Kong, X., & Khambadkone, A. M. (2007). Analysis and
implementation of a high efficiency, interleaved currentfed
full bridge converter for fuel cell system. IEEE
Transactions on Power Electronics, 22(2), 543-550.
https://doi.org/10.1109/TPEL.2006.889985
[3]. Liu, C., & Lai, J. S. (2007). Low frequency current ripple
reduction technique with active control in a fuel cell
power system with inverter load. IEEE Transactions on
Power Electronics, 22(4), 1429-1436. https://doi.org/10.1109/TPEL.2007. 900594
[4]. Ismail, E. H., Al-Saffar, M. A., Sabzali, A. J., & Fardoun,
A. A. (2008). A family of single-switch PWM converters with
high step-up conversion ratio. IEEE Transactions on
Circuits and Systems I: Regular Papers, 55(4), 1159-1171.
https://doi.org/10.1109/TCSI.2008.916427
[5]. Erickson, R. W., & Maksimovic, D. (2001).
Fundamentals of Power Electronics. Springer, (pp. 904).
[6]. Li, W., & He, X. (2008). A family of interleaved DC–DC
converters deduced from a basic cell with winding-crosscoupledinductors
(WCCIs) for high step-upor step-down
conversions. IEEE Transactions on Power Electronics,
23(4), 1791-1801. https://doi.org/10.1109/TPEL.2008.925204
[7]. Li, W., & He, X. (2007). An interleaved winding-coupled
boost converter with passive lossless clamp circuits. IEEE
Transactions on Power Electronics, 22(4), 1499-1507.
https://doi.org/10.1109/TPEL.2007.900521
[8]. Li, W., Zhao, Y., Deng, Y., & He, X. (2010). Interleaved
converter with voltage multiplier cell for high step-up and
high-efficiency conversion. IEEE Transactions on Power
Electronics, 25(9), 2397-2408. https://doi.org/10.1109/TPEL.2010.2048 340
[9]. Hsieh, Y. P., Chen, J. F., Liang, T. J., & Yang, L. S. (2010).
A novel high step-up DC–DC converter for a microgrid
system. IEEE Transactions on Power Electronics, 26(4),
1127-1136. https://doi.org/10.1109/TPEL.2010.2096826
[10]. Xie, R., Li, W., Zhao, Y., Zhao, J., He, X., & Cao, F.
(2010). Performance analysis of isolated ZVT interleaved
converter with winding-cross-coupled inductors and
switched-capacitors. In 2010, IEEE Energy Conversion
Congress and Exposition, 2025-2029. https://doi.org/ 10.1109/ECCE. 2010.5618103
[11]. Li, W., Li, W., He, X., Xu, D., & Wu, B. (2011). General
derivation law of nonisolated high-step-up interleaved
converters with built-in transformer. IEEE Transactions on
Industrial Electronics, 59(3), 1650-1661. https://doi.org/10.1109/TIE. 2011.2163375
[12]. Tseng, K. C., Huang, C. C., & Shih, W. Y. (2012). A high
step-up converter with a voltage multiplier module for a
photovoltaic system. IEEE Transactions on Power
Electronics, 28(6), 3047-3057. https://doi.org/10.1109/TPEL.2012. 2217157
[13]. Li, W., Zhao, Y., Wu, J., & He, X. (2009). Interleaved
high step-up converter with winding-cross-coupled
inductors and voltage multiplier cells. IEEE Transactions on
Power Electronics, 27(1), 133-143. https://doi.org/10.1109/TPEL.2009. 2028688
[14]. Tseng, K. C., & Huang, C. C. (2013). High step-up
high-efficiency interleaved converter with voltage
multiplier module for renewable energy system. IEEE
Transactions on Industrial Electronics, 61(3), 1311-1319.
https://doi.org/10.1109/TIE.2013.2261036
[15]. Hu, Y., Deng, Y., Long, J., Lu, X., & He, X. (2013). A
high step-up passive absorption circuit used in nonisolated
high step-up converter. 2013 Twenty-Eighth
Annual IEEE Applied Power Electronics Conference and
Exposition (APEC), 1966-1971. https://doi.org/10.1109/APEC.2013. 6520564
[16]. Gummi, K., & Ferdowsi, M. (2008). Synthesis of
double-input dc-dc converters using a single-pole triplethrow
switch as a building block. In 2008 IEEE Power
Electronics Specialists Conference, 2819-2823. https://doi.org/10.1109/PESC.2008.4592373
[17]. Prabhala, V. A. K., Somayajula, D., & Ferdowsi, M.
(2009). Power sharing in a double-input buck converter using dead-time control. In 2009 IEEE Energy Conversion
Congress and Exposition, 2621-2626. https://doi.org/10.1109/ECCE. 2009.5316355
[18]. Lee, S., Kim, P., & Choi, S. (2012). High step-up softswitched
converters using voltage multiplier cells. IEEE
Transactions on Power Electronics, 28(7), 3379-3387.
https://doi.org/10.1109/TPEL.2012.2227508
[19]. Young, C. M., Chen, M. H., Chang, T. A., Ko, C. C., &
Jen, K. K. (2012). Cascade Cockcroft–Walton voltage
multiplier applied to transformerless high step-up DC–DC
converter. IEEE Transactions on Industrial Electronics,
60(2), 523-537. https://doi.org/10.1109/TIE.2012.2188255
[20]. Dickson, J. F. (1976). On-chip high-voltage
generation in MNOS integrated circuits using an improved
voltage multiplier technique. IEEE Journal of Solid-State
Circuits, 11(3), 374-378. https://doi.org/10.1109/JSSC.1976.1050739
[21]. Jang, Y., & Jovanovic, M. M. (2007). Interleaved
boost converter with intrinsic voltage-doubler
characteristic for universal-line PFC front end. IEEE
Transactions on Power Electronics, 22(4), 1394-1401.
https://doi.org/10.1109/TPEL.2007.900502
[22]. Prudente, M., Pfitscher, L. L., Emmendoerfer, G.,
Romaneli, E. F., & Gules, R. (2008). Voltage multiplier cells
applied to non-isolated DC–DC converters. IEEE
Transactions on Power Electronics, 23(2), 871-887.
https://doi.org/10.1109/TPEL.2007.915762
[23]. Shen, Z. J., Xiong, Y., Cheng, X., Fu, Y., & Kumar, P.
(2006). Power MOSFET switching loss analysis: A new
insight. In Conference Record of the 2006 IEEE Industry
Applications Conference Forty-First IAS Annual Meeting,
3, 1438-1442. https://doi.org/10.1109/IAS.2006.256719
