Study of Self-Charging Features in Hybrid Vehicle

Abdul Rahman M.*, Abhinesh Rajan H.**, Deena Dhayalan V.***, Gokulakrishnan K.****
*-**** Department of Mechanical Engineering, SRM Valliammai Engineering College, Kattankulathur, Kanchipuram, Tamil Nadu, India.
Periodicity:May - July'2022
DOI : https://doi.org/10.26634/jps.10.2.18844

Abstract

Pollution and energy crises become more and more visible, and Hybrid Electric Vehicles (HEVs) are gaining more and more popularity around the world. To study the perception of alternative technology in an automobile, the project "Hybrid Vehicle Using Self-Charging Functions" is being carried out. A hybrid vehicle uses two or more different types of energy and combines it with electrical power. When the motor is started, the magnetic coil present in the crank starts to rotate. The rotation creates a higher voltage flux. In this case, an additional alternative magnet coil is connected in parallel with the magnet coil using gears. As the coil rotates, the energy generated in the main coil is used for ignition, while the energy generated in the alternate coil is sent to the rectifier and stored in the battery. While the car runs out of fuel, the hybrid switch is activated, then the energy stored in the battery is transferred to the wheel hub, and it starts to work. Since ancient times, people have been using vehicles for transportation and some personal needs. It pollutes the environment with gasoline and diesel fuel. It is burned in the engine for energy, but as some unburned gases come out, it affects the human respiratory system. Therefore, the automotive industry has introduced a battery vehicle (hybrid vehicle). It consumes zero emissions and is environmentally friendly. For a while, it only appeared in cars, not twowheelers, so for a change, if it creates a hybrid two-wheeler combined with a motor and battery, it will have power, fuel efficiency, and fewer emissions. It has power and environmental fixes in a two-wheeler. When driving at an average speed of 0 to 50 mph, it consumes more fuel due to high torque instead of power from the engine. It receives power from the battery above 50 to 100, and when the engine comes to work, there is power from the engine at that time with low torque, so the motorcycle will not consume much fuel, which means that in motion, the two-wheeler is running on battery, and in the absence of motion, in an engine with such low emissions.

Keywords

Hybrid Vehicle, Magnet Coil, Rectifier, Alternative Coil.

How to Cite this Article?

Rahman, M. A., Rajan, H. A., Dhayalan, V. D., and Gokulakrishnan, K. (2022). Study of Self-Charging Features in Hybrid Vehicle. i-manager’s Journal on Power Systems Engineering, 10(2), 29-38. https://doi.org/10.26634/jps.10.2.18844

References

[1]. Charles, S., Fredrick, C., Gopinath, K., & Manoj, P. D. (2012). Design and development of an extended range electric hybrid scooter. IRACST Engineering Science and Technology: An International Journal (ESTIJ), 2, 196-203.
[2]. Elias, B. P., Devassykutty, D., George, J., Akhila, K. (2015). Hybrid bicycle. IOSR Journal of Electrical and Electronics Engineering (IOSR-JEE), 100-104.
[3]. Harris, A. P. (1971). Honors Degree – Special Report - Automotive Electronic Ignition system. The City University London.
[4]. Kricke, C., Hagel, S., Neuendorf, N., Wältermann, P., & Hablizel, A. (1998, September). A hybrid electric vehicle simulation model for component design and energy management optimization. In Proc. FISITA World Automotive Congress.
[5]. Marston, R. M. (1970). Capacitor Discharge Ignition System. Wireless World.
[6]. Mishra, K. S., Gadhawe, S. V., Chaudhari, D. C., Varma, B., & Barve, S. B. (2016). Design and development of solar hybrid bicycle. International Journal of Current Engineering and Technology, (4), 377-381. https://doi.org/10.14741/Ijcet/22774106/Spl.4.2016.76
[7]. Prasad, N. S., & Nataraj, K. R. (2014). Design and development of hybrid electric two-wheeler suitable for Indian road conditions. International Journal of Electrical, Electronics and Data Communication, 2(9), 59-62.
[8]. Rajagopalan, G., Washington, G., Rizzoli, G., & Guezennec, Y. (2003). Development of Fuzzy Logic and Neural Network Control and Advanced Emissions Modeling for Parallel Hybrid Vehicles. National Renewable Energy Laboratory, 1-46.
[9]. Santini, D. J., Patterson, P. D., & Vyas, A. D. (2000). Importance of vehicle costs, fuel prices, and fuel efficiency in hybrid electric vehicle market success. Transportation Research Record, 1738(1), 11-19. https://doi.org/10.3141/1738-02
[10]. Shimizu, H., Harada, J., Bland, C., Kawakami, K., & Chan, L. (1997). Advanced concepts in electric vehicle design. IEEE Transactions on Industrial Electronics, 44(1), 14-18. https://doi.org/10.1109/41.557494
[11]. Tuck, C. D. S. (1991). Modern Battery Technology. Ellis Horwood, New York.
If you have access to this article please login to view the article or kindly login to purchase the article

Purchase Instant Access

Single Article

North Americas,UK,
Middle East,Europe
India Rest of world
USD EUR INR USD-ROW
Pdf 35 35 200 20
Online 35 35 200 15
Pdf & Online 35 35 400 25

Options for accessing this content:
  • If you would like institutional access to this content, please recommend the title to your librarian.
    Library Recommendation Form
  • If you already have i-manager's user account: Login above and proceed to purchase the article.
  • New Users: Please register, then proceed to purchase the article.