i-manager Publications

Simulation Analysis of PV Based Two Stage Interleaved Boost Converter for EV Application

0*, R. Zahira**

*-** Department of Electrical and Electronics Engineering, B. S. Abdur Rahman Crescent Institute of Science and Technology, Chennai, Tamil Nadu, India.

Periodicity:February - April'2021
DOI : https://doi.org/10.26634/jps.9.1.18107

Abstract

Solar PV power generation systems are connected to the load using a two-stage interleaved boost converter (IBC). Maximum Power Point Tracking (MPPT) controllers are used in IBC circuits to extract the most power possible from the source. This paper examines the simulation of a PV based two stage IBC for EV applications using perturb and observe (P&O) MPPT algorithm. At a constant temperature of 25 ^oC, a solar PV device with various irradiations is used. The PWM technique is used to produce pulses for the IBC's MOSFET. The conventional boost converter (BC) is unreliable in high-power applications. To reduce the stress of switches, two-stage 1800 phase shifting techniques have been used. The IBC method should be used in high-power applications to increase efficiency. Complete simulation has been analyzed with a switching frequency at 25 kHz. To boost the output voltage to 172.4 V, simulate and run 1 second of PV-based two-stage IBC with RL load. The phase shifting approach has been used to eliminate overall losses and harmonics. The simulated output results are obtained by the saturated waveform. Based on the interleaved approach, the overall efficiency of 88.5 percent has been obtained with the entire simulation simulated with MATLAB/Simulink software.

Keywords

Maximum Power Point Tracking, Boost Converter, Interleaved Boost Converter, Photo Voltaic, Perturb and Observe, Electric Vehicle.

How to Cite this Article?

Suresh, S., and Zahira, R. (2021). Simulation Analysis of PV Based Two Stage Interleaved Boost Converter for EV application. i-manager's Journal on Power Systems Engineering, 9(1), 8-14. https://doi.org/10.26634/jps.9.1.18107

References

[1]. Benisha, S., Lakshmi, D., Zahira, R., & Ezhilarasi, G. (2018). DC – DC converter integrated with voltage multiplier for high voltage gain. International Journal of Advanced Research Trends in Engineering and Technology, 5(S-6), 21-26.

[2]. Gaur, P., Verma, Y. P., & Singh, P. (2015, December). Maximum power point tracking algorithms for photovoltaic applications: A comparative study. In 2015, 2^nd International Conference on Recent Advances in Engineering & Computational Sciences (RAECS) (pp. 1-5). IEEE. https://doi.org/10.1109/RAECS.2015.7453430

[3]. Gomathy, S. S. T. S., Saravanan, S., & Thangavel, S. (2012). Design and implementation of maximum power point tracking (MPPT) algorithm for a standalone PV system. International Journal of Scientific & Engineering Research, 3(3), 1-7.

[4]. Henn, G. A., Silva, R. N. A. L., Praca, P. P., Barreto, L. H., & Oliveira, D. S. (2010). Interleaved-boost converter with high voltage gain. IEEE Transactions on Power Electronics, 25(11), 2753-2761. https://doi.org/10.1109/TPEL.2010.204 9379

[5]. Kamtip, S., & Bhumkittipich, K. (2011, May). Design and analysis of interleaved boost converter for renewable energy applications. In 9^th Eco-Energy and Materials Science and Engineering Symposium, Thailand.

[6]. Kumari, J. S., & Babu, C. S. (2011). Comparison of maximum power point tracking algorithms for photovoltaic system. International Journal of Advances in Engineering & Technology, 1(5), 133-147.

[7]. Kundu, S., Gupta, N., & Kumar, P. (2016, November). Review of solar photovoltaic maximum power point tracking techniques. In 2016, 7^th India International Conference on Power Electronics (IICPE) (pp. 1-6). IEEE. https://doi.org/10.1109/IICPE.2016.8079494

[8]. Seyezhai, R., & Mathur, B. L. (2012). Design and implementation of interleaved boost converter for fuel cell systems. International Journal of Hydrogen Energy, 37(4), 3897-3903. https://doi.org/10.1016/j.ijhydene.2011.09.082

[9]. Shenoy, K. L., Nayak, C. G., & Mandi, R. P. (2017). Design and implementation of interleaved boost converter. International Journal of Engineering and Technology (IJET), 9(3S), 496-502. https://doi.org/10.21817/ ijet/2017/v9i3/170903S076

[10]. Slah, F., Mansour, A., Hajer, M., & Faouzi, B. (2017). Analysis, modeling and implementation of an interleaved boost DC-DC converter for fuel cell used in electric vehicle. International Journal of Hydrogen Energy, 42(48), 28852- 28864. https://doi.org/10.1016/j.ijhydene.2017.08.068

[11]. Swamy, H. M., Guruswamy, K. P., & Singh, S. P. (2013, December). Design, modeling and analysis of two level interleaved boost converter. In 2013, International Conference on Machine Intelligence and Research Advancement (pp. 509-514). IEEE.

[12]. Xue, T., Minxin, Z., & Songtao, Y. (2016, June). Maximum power point tracking for photovoltaic power based on the improved interleaved boost converter. In 2016, IEEE 11th Conference on Industrial Electronics and Applications (ICIEA) (pp. 2215-2218). IEEE. https://doi.org/ 10.1109/ICIEA.2016.7603957

[13]. Zahira, R., Amirtharaj, S., Selvarani, M., & Lakshmi, D. (2019). Design of MOSFET inverter for a grid connected photovoltaic system. In Proceedings of AICTE Sponsored National Conference on Recent Advances in On-Board Ship Automation (RAOBSA-2019 (pp. 253- 256).

	North Americas,UK, Middle East,Europe		India	Rest of world
	USD	EUR	INR	USD-ROW
Pdf	35	35	200	20
Online	35	35	200	15
Pdf & Online	35	35	400	25

Simulation Analysis of PV Based Two Stage Interleaved Boost Converter for EV Application

Abstract

Keywords

How to Cite this Article?

References

If you have access to this article please login to view the article or kindly login to purchase the article

Purchase Instant Access

Options for accessing this content: