Fork Shaped MIMO Planar Antenna for UWB Application

Amit Kumar Singh*, Rajan Mishra**
* PG Scholar, Department of Communication Engineering, Madan Mohan Malaviya University of Technology, Gorakhpur, India.
** Assistant Professor, Department of Electronics and Communication Engineering, Madan Mohan Malaviya University of Technology, Gorakhpur, India.
Periodicity:May - July'2016
DOI : https://doi.org/10.26634/jcs.5.3.8061

Abstract

In this paper, a fork shaped MIMO antenna has been proposed with an overall size of 26×40×0.8 mm , that is essentially used for the Ultra-WideBand (UWB) applications. It is fabricated on the FR_4 Epoxy substrate. The material has a dielectric constant of 4.4 and a loss tangent of 0.02 and the most important fact is that, it is very cheap and easily available. The proposed antenna consists of two fork shaped patch on the top surface of the substrate with a microstrip feed of 50Ω is positioned perpendicular to each other to attain good isolation. To increase the impedance bandwidth and to improve the isolation, two long ground stubs are placed on the bottom surface of the substrate. A small strip is used to connect the two ground planes together to form the common ground at the bottom surface. The performance of the fork shaped MIMO antenna can be measured in terms of the reflection coefficient at the two input ports, coupling between the input ports, peak gain and radiation pattern. The results show that the fork shaped MIMO antenna has an impedance bandwidth greater than 3.1 to 11.1 GHz with a low mutual coupling less than -15 dB throughout the band. It has a VSWR of less than 2, throughout the band and it has a good gain and an omnidirectional radiation pattern.

Keywords

Multiple-Input-Multiple-Output (MIMO), Fork Shaped Patch Antenna, Diversity, Ultra-WideBand (UWB).

How to Cite this Article?

Singh, A. K., and Mishra, R. (2016). Fork Shaped MIMO Planar Antenna for UWB Application. i-manager’s Journal on Communication Engineering and Systems, 5(3), 1-6. https://doi.org/10.26634/jcs.5.3.8061

References

[1]. Federal Communications Commission (FCC), (2002). Revision of part 15 of the Commissions Rules Regarding Ultra- Wideband Transmission Systems First Report and Order, ET Docket 98-153 FCC 02-48, Adopted FEB. 2002; Released, Apr, 2002.
[2]. Li Liu, S. W. Cheung, and T. I. Yuk, (2013). “Compact MIMO Antenna for Portable Devices in UWB Applications”. IEEE Transactions of Antennas and Propagation, Vol. 61, No.8, pp. 4257-4264.
[3]. Manuel Prassana K, and S. K. Behera, (2013). “Compact Two-Port UWB MIMO Antenna System With High Isolation Using a Fork-Shaped structure”. IEEE International Conference on Communication and Signal Processing (ICCSP), Melmaruvathur, India, pp. 726-729.
[4]. E.A Daviu, M. Gallo, B.B. Clemente, and M.F. Battaler, (2010). “Ultrawideband Slot Ring Antenna for Diversity Applicationa”. Electron Lett, Vol.46, No.7, pp. 478-480.
[5]. Jia-Yi Sze, and Chi-Chaan Chang, (2008). “Circularly Polarized Square Slot Antenna With a Pair of Inverted–L Grounded Strips”. IEEE Antenna and Wireless Propagation Letters, Vol. 7, pp. 149-151.
[6]. Anil Kumar Gautam, Swati Yadav, and Binod Kr Kanaujia, (2013). “A CPW- Fed Compact UWB Microstrip Antenna”. IEEE Antennas and Wireless Propagation Letters, Vol. 12, pp. 151-154.
[7]. W. Mazhar, M. A.Tarar, F. A. Tahir, Shan Ullah, and F. A. Bhatti, (2013). “Compact Microstrip Patch Antenna for Ultrawideband Applications”. Piers Proceedings, Stockholm, Sweden, pp. 1100-1104.
[8]. Y.F. K.L Lau ,Q. Xue, and C.H. Chan, (2004). “Experimental Studies of Printed Wide Slot Antenna for Wideband Applications”. IEEE Antennas and Wireless Propagation Letters, Vol. 3, No. 1, pp. 273-275.
[9]. Horng-Dean Chen, (2003). “Broadband CPW-Fed Square Slot Antennas With Widened Tuning Stub”. IEEE Transactions on Antennas and Propagation, Vol. 51, No. 8, pp. 1982-1986.
[10]. Jyh Ying Chiou, and Kin-Lu Wong, (2003). “A Broad- Band CPW-Fed Strip-Loaded Square Slot Antenna”. IEEE Transactions on Antennas and Propagation, Vol. 51, No. 4, pp. 719-721.
[11]. Manuel Prasanna K and S. K. Behera, (2013). “A Hexagonal MIMO Antenna System With Defected Ground Structure to Enhance Bandwidth and Isolation”. IEEE International Conference on Communication and Signal Processing (ICCSP), Melmaruvathur, India 3-5.
[12]. S. Hong, K. Chung, J Lee, S. Jung, S. S. Lee, and J Choi, (2008). “Design of a Diversity Antenna with Stubs for UWB Applications”. Microw. Opt. Techin. Lett., Vol. 50, No. 5, pp. 1352-1356.
[13]. S. Zhang, Z. Ying, J. Xiong, and S. He, (2009). “Ultra- WideBand MIMO/Diversity Antennas with a Tree-like Structure to Enhance Wideband Application”. IEEE Antennas Wireless Propag. Lett., Vol. 8, pp.1279-1282.
[14]. Y. Cheng, W. J. Lu, and C. H. Cheng, (2010). “Printed Diversity Antenna for UWB Applications”. In Proc. Int. Conf. Ultra-wideband ('CUWB'2010), Nanjing, China, Vol. 1, pp. 1- 4.
[15]. H.K Yoon, Y.J. Yoon, H. Kim, and C.H. Lee, (2011). “Flexible Ultra-WideBand Polarization Diversity Antenna with Band-Notch Function”. IET Microw. Antennas Wireless Propag. Lett., Vol. 5, No.12, pp.1463-1470.
[16]. J.M. Lee, K.B. Kim, H.K. Ryu, and J.M. Woo, (2012). “A Compact Ultra-WideBand MIMO Antenna in WLAN Band Rejected Operation for Mobile Devices”. IEEE Antennas Wireless Propag. Lett., Vol. 11, pp. 990-993.
If you have access to this article please login to view the article or kindly login to purchase the article

Purchase Instant Access

Single Article

North Americas,UK,
Middle East,Europe
India Rest of world
USD EUR INR USD-ROW
Pdf 35 35 200 20
Online 35 35 200 15
Pdf & Online 35 35 400 25

Options for accessing this content:
  • If you would like institutional access to this content, please recommend the title to your librarian.
    Library Recommendation Form
  • If you already have i-manager's user account: Login above and proceed to purchase the article.
  • New Users: Please register, then proceed to purchase the article.