Switchable Filter between Band Pass and Band Stop Responses

Shivi Batham*, Arvind Kumar Pandey**, R. K. Chauhan***
* PG Scholar,Department of Electronics and Communication Engineering, Madan Mohan Malaviya University of Technology, Gorakhpur, Uttar Pradesh, India.
** Research Scholar,Department of Electronics and Communication Engineering, Madan Mohan Malaviya University of Technology, Gorakhpur, Uttar Pradesh, India.
*** Associate Professor,Department of Electronics and Communication Engineering, Madan Mohan Malaviya University of Technology, Gorakhpur, Uttar Pradesh, India.
Periodicity:May - July'2016
DOI : https://doi.org/10.26634/jes.5.2.11386

Abstract

This paper presents a microwave switchable filter between Band Pass and Band Stop responses. The structure is compact as compared to traditional structures and has no via or DGS in it. The band pass filter uses an interdigital structure and two hairpins attached in a cascaded manner and the band stop filter is designed by shorting finger of the interdigital structure. The band pass filter allows the frequencies from 4.4 to 11.6 GHz and the band stop filter stops the interference of C-Band. This filter is reconfigurable. The filter is reconfigured from one response to another by using a switch. A PN junction diode is used as a switch. This type of filter finds its application where both band pass and band stop filters are required in the same system. To eliminate the high power interference close to the desired signal in a high interference environment, the filter can be used in the band stop mode and in a low interference environment band pass filter is used. So this type of filter can be used to overcome the problem of interference. The structure is designed on FR4 substrate.

Keywords

Switchable Filter, Interdigital Capacitor, Microwave/RF Switch

How to Cite this Article?

Batham,S., Pandey,A,K., and Chauhan.R.K. (2016). Switchable Filter between Band Pass and Band Stop Responses. i-manager's Journal on Embedded Systems, 5(2), 20-24. https://doi.org/10.26634/jes.5.2.11386

References

[1]. Y.H. Cho, and G.M. Rebeiz, (2014). “0.7–1.0 GHz Reconfigurable Band pass-to-Band stop Filter with selectable 2- and 4 -Pole Responses”. In: IEEE Transactions on Microwave Theory and Techniques, Vol.62, No.11, pp.2626-2632.
[2]. R.S. Li, and F.C. Chen, (2016). “A tunable bandpass-tobandstop filter using PIN diode”. In: 2016 IEEE International Conference on Ubiquitous Wireless Broadband (ICUWB), Nanjing, pp.1-3.
[3]. Young-Ho Cho, and Gabriel M. Rebeiz, (2014). “Twoand four-pole tunable 0.7–1.1 GHz bandpass-tobandstop filters with bandwidth control”. IEEE Trans. Microw. Theory Techn., Vol.62, No.3, pp.457–453.
[4]. H.H. Singmarsson, J. Lee, D. Peroulis, and W.J. Chappell, (2010). “Reconfigurable-order bandpass filter for frequency agile systems”. IEEE MTT-S Int. Microw. Symp., Anaheim, CA, pp.1756–1759.
[5]. Y.M. Chen, S.F. Chang, C.Y. Chou, and K.H. Liu, (2009). “A reconfigurable bandpass–bandstop filter based on varactor-loaded closed-ring resonators”. IEEE Microw. Mag., Vol.10, No.1, pp.138–140.
[6]. M.F. Karim, Y.X. Guo, Z.N. Chen and L.C. Ong, (2008). “Miniaturized reconfigurable filter using PIN diode for UWB applications”. 2008 IEEE MTT-S International Microwave Symposium Digest, Atlanta, pp.1031- 1034.
[7]. A.K. Pandey, Y. Gaurav, and R.K. Chauhan, (2016). “Miniaturized UWB BPF with a Notch Band at 5.8 GHz using Cascaded Structure of Highpass and Lowpass Filter”. In Suresh Chandra Satapathy, et al. (Eds.), Information Systems Design and Intelligent Applications, Springer, Vol.434, pp.525-532.
[8]. J. Xu, (2016). “A Microstrip Switchable Filter with Four Operating Modes”. In: IEEE Microwave and Wireless Components Letters, Vol.26, No.2, pp.101-103.
[9]. S.F. Chao, C.H. Wu, Z.M. Tsai, H. Wang, and C.H. Chen, (2006). “Electronically Switchable Bandpass Filters using Loaded Stepped-Impedance Resonators”. In: IEEE Transactions on Microwave Theory and Techniques, Vol.54, No.12, pp.4193-4201.
[10]. Montree Kumngern, Peerawut Suwanjan, and Kobchai Dejhan, (2013). “Electronically tunable voltage mode universal filter with single-input five-output using simple OTAs”. International Journal of Electronics, Vol.100, No.8, pp.1118-1133.
If you have access to this article please login to view the article or kindly login to purchase the article

Purchase Instant Access

Single Article

North Americas,UK,
Middle East,Europe
India Rest of world
USD EUR INR USD-ROW
Pdf 35 35 200 20
Online 35 35 200 15
Pdf & Online 35 35 400 25

Options for accessing this content:
  • If you would like institutional access to this content, please recommend the title to your librarian.
    Library Recommendation Form
  • If you already have i-manager's user account: Login above and proceed to purchase the article.
  • New Users: Please register, then proceed to purchase the article.